Made In Great Britain

Direct from our factory

Delivered to Ireland

VAT and duties included

Product Test Results

All test results published

Expert Technical Advice

Call or chat with our team

Overview

Overview ⓘ

The pencil test pushes pencils of increasing hardness across a cured coating. The result is the hardest pencil that leaves no mark, on the scale that runs from 9B, the softest, through HB to 9H.

Film hardness is a coating's resistance to being dented or marked by something hard pressed against it. The pencil test is the simplest way to grade it, and it uses the same hardness scale as drawing pencils.

What the test measures

The test finds the hardest pencil lead that can be pushed across the cured film without marking it.

How the test is carried out

The method is ISO 15184.

  • The coating is applied to a flat, rigid panel and left to cure fully.
  • A pencil is sharpened to expose the lead, and the tip is rubbed flat on abrasive paper so it has a square edge.
  • The pencil is held in a small trolley at 45° to the surface, under a load of 750 g.
  • It is pushed forward across the film for a short distance.
  • The film is examined. The test is repeated with harder pencils until one marks it.

How to read the result

The scale runs from soft to hard.

Grades Where they sit
9B to B The soft end. 9B is the softest.
HB and F The middle.
H to 9H The hard end. 9H is the hardest.

The higher the B number, the softer the lead. The higher the H number, the harder. The result is the hardest pencil that left no mark. A coating graded 2H was not marked by a 2H pencil, and was marked by a 3H.

What it means in use

A harder film resists marking from point contact: chair legs, stones in a tyre tread, tools set down on a painted surface. Hardness also builds as a coating cures, so the test is one way to follow cure.

What the result does not tell you

Hard does not mean tough. A very hard film can be brittle, and may chip under impact or crack when the surface flexes. Flexible coatings for timber, roofs and cladding are softer by design. See Flexibility (Mandrel Bend Test).

The steps on the scale are coarse, and pencils of the same grade vary between makers. Two laboratories can differ by a grade on the same film.

Hardness depends on cure. A result taken at seven days does not describe the film at 24 hours.

Pencil hardness is not scratch or wear resistance. See Scratch Resistance (Sclerometer) and Abrasion Resistance (Taber Abrasion).

On our product pages

Where a product has been tested, its page shows the result, the method and, where the method has one, the rating. Results published on this site come from internal testing to the stated method. They are given for technical reference and comparison.

If a figure you need is not shown, ask our technical team.

Leave a comment

Please note, comments need to be approved before they are published.

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.